Key Programming for 9-3's through 2003 and all 9-5's

Our Prices:
Two remote-head keys: $595.00
Three remote-head keys: $695.00

Call us to place an order.
435-759-2495

• No need for programming equipment.
• Go to the parts department at your Saab dealer and acquire the key code for your car.
  The key code allows us to cut your keys. This requires your proof of ownership and photo ID.
• Simply remove the TWICE module from your vehicle.
• Ship the TWICE module, the key code, and the order form to us.
• After receiving your module we program and ship it by the next business day.
• We do not charge you until we verify the module works on our simulators.
• USPS Express return shipping is already included in the price.
• Re-install the returned module, and start the vehicle with your new keys.

Let's Begin

TWICE Module Removal Instructions

Mechanical Skill Level Required: Moderate
Additional Professional Programming Required: None. Plug and Drive.

Tools needed to remove twice module:

• 3/8” Ratchet
• 3/8” drive, 2”- 3” extension
• 10mm Deepwell Socket
• Torx T-40 Bit (3/8 drive)
• Flat Blade Screwdriver

Follow these steps for removal of module:

1. Using a Torx T-40 bit in a ratchet (I find a 2” extension helps), remove the 4 seat bolts holding the seat to the floor.
   (Note the bolts are tight and have thread-lock on them to prevent them from coming loose.)
2. Unplug the seat memory module / side airbag wire harness from under the seat, the harness unplugs by pulling out the burgundy color clip on the plug. See pic of harness to see the clip. And unclip the bungee cord attached to the bottom of the seat frame.
   
3. Move the driver seat back, into the back seat. You can not take the seat out of the car easily because of the seat belt.
4. Remove the door sill trim, it just lifts out. (I use a screwdriver.) Pry between the carpet and the trim until the pressure clip releases. If the clips stay in the floor, just pull them out and slide them back onto the sill trim.
   
   
5. Pull up the carpet to expose the floor heater vent.
   
6. Remove the plastic rivet holding the vent to the floor by pushing in the button in the center of the rivet. The rivet can then be lifted out, the center pin can be pushed up (out the top) to reset the rivet for reuse. Next remove the 10mm plastic nut holding the floor vent down. (Using a 10mm deep well socket and ratchet)
   
7. Lift the vent up to clear the twice module.
   
8. Now you can remove 10mm plastic nut(s). 1 nut for 9-3’s or 3 nuts for 9-5’s.
   
9. Pull the release handle on the wiring harness plug to remove the wiring harness from the module.
   
10. Remove the module from the car.
    
11. Follow packaging instructions and mail module to us.
    

Note: When reinstalling your returned module: Make sure all electical connections are plugged in before turning the key. If the connector under the driver's seat is not connected when the key is turned on, you risk disabling the airbag system and turning on the airbag malfunction light. If this happens, a dealer tool will be required to reset the airbag system and turn off the airbag light.